MIL-DTL-0050872D (AR)
4.4 Conformance inspection.
4.4.1 Inspection lot formation. Lot formation shall be in accordance with MIL-STD-
1916. For the components identified below, each inspection lot of cartridges shall be produced
with components complying with the following constraints:
a. M118 cartridge case loading assemblies metal parts from one interfix number, from
one manufacturer.
b. Projectile metal parts from one lot interfix number, from one manufacturer.
c. Fuzes from no more than two consecutively produced serial lots from one
manufacturer.
d. Primers from one lot number from one manufacturer.
e. Liners and caps from one interfix lot number from one manufacturer.
f. RDX or Composition A-5 from one lot interfix number, from one manufacturer.
g. Loaded spitback assemblies from one lot interfix number, from one manufacturer.
h. Propellant from not more than one lot number from one manufacturer.
4.4.2 Classification of characteristics.
a. Sampling requirements. Inspection sampling requirements for Critical, Major and
Minor characteristics are defined in MIL-STD-1916. Unless specified otherwise, Verification
Level IV shall be used for all characteristics defined as Majors and Verification Level II for all
Minor characteristics; Critical characteristics shall be addressed in accordance with MIL-STD-
1916.
b. Conformance inspection. Conformance inspection shall be performed in accordance
with paragraph 4.4.2.1 through 4.4.2.23. For all conformance inspections the same sample
specimen may be used for all non-destructive examinations or tests.
8
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business