MIL-DTL-0048683B (AR)
4.4 Conformance inspection.
4.4.1 Inspection lot formation. Lot formation shall be in accordance with MIL-
STD-1916. For the components identified below, each inspection lot of projectiles shall
be produced with components complying with the following constraints:
a. Projectile metal parts from one lot interfix number, from one manufacturer.
b. Escapments from no more than two consecutively produced serial lots from
one manufacturer.
c. Flash charge composition from one lot number from one manufacturer.
4.4.2 Classification of characteristics.
a. Sampling requirements. Inspection sampling requirements for Critical, Major
and Minor characteristics are defined in MIL-STD-1916. Unless specified otherwise,
Inspection Level IV shall be used for all characteristics defined as Majors and Inspection
Level II for all Minor characteristics; Critical characteristics shall be addressed in
accordance with MIL-STD-1916.
b. Conformance inspection. Conformance inspection shall be performed in
accordance with paragraph 4.4.2.1 through 4.4.2.19. For all conformance inspections the
same sample specimen may be used for all non-destructive examinations or tests.
9
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business