MIL-DTL-0045585E (AR)
3.4 Workmanship. All parts and assemblies shall be fabricated, loaded and
assembled in a thorough and workmanlike manner. They shall be free of burrs, chips,
sharp edges, cracks, dirt, grease, rust and other foreign matter. The cleaning method used
shall not be injurious to any parts, nor shall the cleaning agents contaminate the parts.
Exterior surface coatings shall be continuous; however a few light scratches not exposing
base material may be permitted. All marking and stamping shall be neat and sharply
defined.
4. VERIFICATION
TABLE I. Requirement/Inspection Cross Reference Matrix
Method of inspection
Classes of inspection
N/A - Not Applicable
A - First article
1 - Analysis
B - Conformance
2 - Demonstration
3 - Examination
4 - Test
Inspection
Inspection
Section 3
Section 4
Methods
Class
Requirement
Inspection
Method
NA 1 2 3 4
A
B
3.1
XXX
X
4.3
3.2
XX
X
X
4.4
3.3
X
X
X
4.5.15
3.4
X
X
X
4.5.18
4.1 Classification of inspection. The inspection requirements specified herein are
classified as follows:
a. First article inspection (see 4.3).
b. Conformance inspection (see 4.4).
4.2 Inspection conditions. Unless otherwise specified, all inspections shall be
performed in accordance with the test conditions specified in section 4.5.
4.3 First article. When specified in the solicitation or contract, a sample of the
Link, Cartridge: Metallic Belt, 40MM: M16A2 shall be subjected to first article
inspection in accordance with section 4.3.1 and Table II.
4.3.1 First article quantity. The contractor shall submit a first article for
evaluation in accordance with the provisions of 4.3.2. The first article sample shall
consist of the following items in sample quantities as indicated.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business