MIL-DTL-0063092B (AR)
TABLE II. First article inspection
M583A1 Cartridge, Sub-Assemblies and Components
N0. OF
REQUIREMENT INSPECTION
EXAMINATION OR TEST
SAMPLE
PARAGRAPH
METHOD
UNITS
Cartridge (Dwg.9243881/9317509/9255145)
25
3.2
4.5.9
-Pull Test of Projectile
25
3.2
4.5.10
-Transportation vibration
440
3.4
4.5.11
-Air Pressure
440
3.2
4.5.8
Functioning
440 2/
3.5
4.5.12
- Hot
80 3/
3.5.5
4.5.12.1
- Ambient
280 3/
3.5.6
4.5.12.2
- Cold
80 3/
3.5.7
4.5.12.3
Notes:
2/ The Lot shall be rejected if:
a) Two (2) or more of the total samples have an altitude less than (350) ft.
b) Average altitude of total sample fails to have emission of light at an average altitude of
600±100 ft.
c) Burning time of two (2) or more of the total sample at ambient temperature is less than 22
seconds
d) Any primer blow back (as evidenced by perforation of cup and extrusion of the primer around
the firing pin causing difficulty in opening the weapon
e) Two (2) or more primer misfires
3/ In addition to note two (2) the lot shall be rejected if the criteria in Table IV is not met
4.4 Conformance inspection.
4.4.1 Lot formation. Lot formation shall be in accordance with the lot formation
requirement of MIL-STD-1916. For the components identified below, each inspection lot of
cartridges shall be produced with components complying with the following constraints:
a) Metal parts or components from one interfix lot number from one
manufacturer.
b) Primers from one interfix lot number from one manufacturer.
c) Propellant from one interfix lot number from one manufacturer.
d) Projectile metal parts from one interfix lot number from one manufacturer.
e) Delay composition from not more than one lot number.
f) Igniter composition from not more than one lot number.
g) Black powder from not more than one lot number.
h) Cartridge case loaded assemblies from one interfix lot number from one
manufacturer.
i) Illuminant assemblies from one interfix lot number from one manufacturer.
j) First fire composition from not more than one lot number.
k) Delay assemblies from one interfix lot number from one manufacturer.
4.4.1.1 Lot identification. Visually verify that each lot is identified as the type, caliber,
model, and lot number in accordance with MIL-STD-1168.
7
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business