MIL-C-50527 (MU)
article quantity or portion thereof. Until a first article
quantity is accepted, the contractor is in no way authorized
by the Government to resume regular production unless otherwise
directed by the Contracting Office.
4.3 Inspection provisions
4.3.1 Lot formation. -The term "inspection lot" as used in
this specification.is defined as an essentially homogeneous col-
lection of units of product from which a representative sample
is drawn and inspected to determine conformance with applicable
The sample selected shall represent only that
requirements.
quantity of units from which the sample was drawn and shall not
be construed to represent any prior or subsequent quantities
presented for inspection. Homogeneity shall be considered to exist
provided the inspection lot has been produced by one manufacturer,
in one unchanged process, in accordance with the same drawing,
same drawing revision, same specification and same specification
revision and complies with the provisions for submission of product
as specified in MIL-STD-105. Changes to process, specification, or
drawing not affecting safety, perfomance, Interchangeability, or
storage, as determined by the Government, shall not be deemed to
alter the homogeneity of an inspection lot. All material submitted
for inspection in accordance with this specification shall comply
with the homogeneity criteria specified herein regardless of the
type of sampling procedure which is being applied to determine
conformance with requirements. Lot numbering, as required, shall
be in accordance with MIL-STD-1168.
4.3.2 Examination.- The examinations listed in the following
subparagraphs shall be performed on inspection lots (See 4.3.1)
of the components or assemblies designated in the applicable para-
graph headings. Inspection for critical defects (and major defects,
when so specified) shall be 100 percent. Sampling plans for major
and minor defects shall be in accordance with MIL-STD-105 except
that continuous sampling plans in accordance with MIL-STD-1235 may
be used if approved by the Government. Instead of applying the
AQL's designated herein to the groups of major and minor defects
listed, the contractor may elect to apply AQL's to Individual de-
fects using an AQL of 0.40 percent for each major defect and an
AQL of 0.65 percent for each minor defect. When this method is
elected, it shall be applied to all of the major and minor defects
listed in the applicable subparagraph of this section, except
where 100 percent inspection is specified, and be documented as
part of the contractor's inspection system. Equipment necessary
for the performance of the inspections listed shall be In accor-
dance with 4.3.4.
6
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business