MIL-C-50527 (MU)
with and use these designs accordingly. The contractor may,
however, in connection with non-mandatory designs, and with the
approval of the Government, design alternate inspection equipment
or use comparable commercial equipment to facilitate his operations.
Such contractor-prepared designs or commercial equipment selections
must be approved by the Government prior to fabrication or procuring
of the equipment. Designs shall be submitted for approval as
specified in 6.3.5.
6.3.4 Contractor designs. -Contractor designs are designs of
inspection equipment for which the Government has assigned design
responsibility to the contractor. Contractor designs shall be
supported by detailed drawings which depict all information necessary
to completely fabricate, calibrate and operate an item of inspection
equipment. This requires that the necessary views, dimensions,
materials, finishes, notes, and operating and calibration instruction
be properly depicted in accordance with approved practices to the
extent that further calculation or clarification will not be required
Unless otherwise specified, contractor designs may be developed on
the format the contractor normally employs in his equipment design
procedure provided such format reflects the detail and information
specified above, subject to the following controls: All submitted
contractor designs shall conform to Specification Mil-D-1000,
Category E, Form 2. Legibility and reproducibility shall permit
conventional making of clearly understandable, high-contrast
Contractors shall submit one copy of final designs
reproductions.
as a rolled set, Designs shall be submitted for approval as
13
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business