MIL-C-60943 Cartridge, 40Mm, He, M384 Loading, Assembling And PackingThis specification covers the loading, assembling and packing for one type of cartridge designated as Cartridge, 40mm, ,HE, M384.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11

MIL-C-60943A (MU)

g. Cartridges in less than full belt quantities from any acceptable

lot of cartridges shall be held until a cumulative amount of 3000 cartridges

are obtained or until 1 year has elapsed. These cartridges shall be linked,

packed and shipped in multiples of 50 as a conglomerate lot. No further

ballistic firing need be performed on these cartridges, since these cartridges

came from acceptable lots. Acceptable lots are not accepted on waiver. If at

the end of 1 year, 3000 cartridges are not obtained, the cumulative amount of

cartridges shall be linked, packed and shipped in multiples of 50 and the remaining

cartridges shall be destroyed.

4.3.2 Examination. -Sampling plans and procedures for the following

classifications of defects shall be in accordance with MIL-STD-105 (ABC-STD-105),

except that, inspection for Critical defects shall be 100 percent. Contractor's

sampling plans, if used, shall be approved by the Government, and shall provide,

as a minimum, the protection afforded the Government by the sampling plans in

MIL-STD-105. Continuous sampling plans in accordance with MIL-STD-1235 may be

used if approved by the procuring activity. Also, at the option of the procuring

activity, AQL's and sampling plans may be applied to the individual characteristics

listed using an AQL of 0.40 percent for each Major defect and an AQL of 0.65 percent

for each Minor defect except where 100% inspection is specified. Equipment

necessary for the performance of the inspections listed shall be in accordance with

4.3.4.

4.3.2.1 Cartridge case assembly, prior to loading (See Dwg 8886327 covering

a detail of Dwg 8886397). -

Method of

Code No

Defects